Installation, Connection And Initial Commissioning; Choosing A Suitable Location; Positioning - hanseatic WQP12-7635Q Gebrauchsanleitung

Installation, connection and initial commissioning

Choosing a suitable location

CAUTION!
Risk of injury!
The appliance is heavy and bulky. Im-
proper handling of the appliance may
result in injury.
Seek the help of another person dur-
■
ing transport, installation and assem-
bly.
If a trolley is used to move the appli-
■
ance, the appliance must be moved
as shown on the packaging.
Only lift the appliance as shown on
■
the packaging.
Remove all obstacles on the transport
■
route and from the installation loca-
tion, e.g. open doors and clear away
objects lying on the fl oor.
The planned location must fulfil the following
prerequisites:
– The location must be a dry and frost-safe
room with a firm ground.
– In order to install the connection pipes, the
dishwasher must be positioned near to a
washing/dishwashing basin or the floor
drain.

Positioning

You can position the dishwasher in two ways:
– as a freestanding appliance in the room.
The space requirement corresponds to the
aforementioned appliance dimensions.
– built under a worktop. In this case, you
must take the required recess dimensions
into consideration.
• Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
Installation, connection and initial commissioning
Freestanding
1. Place the dishwasher in the desired posi-
2. In order to equalise unevenness in the
Appliance measurements
59.8 cm
tion.
floor and set up the dishwasher on a level
horizontal base, you can screw the four
adjustable feet (36) in or out. The adjust-
able feet have slots around their circum-
ference. Insert a screwdriver and turn the
adjustable foot.
Use a spirit level to set up the dishwasher.
Page EN-23
84.5 cm
60.0 cm
(36)