Herunterladen Inhalt Inhalt Diese Seite drucken

Charging The Rechargeable Battery; Inserting The Batteries; Controller Functions - Carrera RC 370160139 Drift Car Montage- Und Betriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Do not operate the car beneath overhead high-voltage cables or broad-
C
casting masts or during a storm! Atmospheric disturbances can affect the
operation of the vehicle. When there a large temperature differences be-
tween your car's garage and the running track, please wait until the vehi-
cle has had time to acclimatise. This will help prevent conden sation form-
ing and the possibility of malfunctions resulting.
Never operate the product on grass surfaces. There is the risk of grass
D
hindering the movement of the axles, which can lead to the motor over-
heating. Do not use the Carrera RC vehicle for transporting goods, per-
sons or animals.
Never use the Carrera RC vehicle outdoors during rain or snowfall. The car
E
must not be run through water, puddles and snow, and must always be kept
stored in a dry place. Wet surfaces without puddles will not affect the car's
performance as the electronic equipment is protected against spray.
Never operate the vehicle near rivers, ponds or lakes, to avoid the risk of
F
the Carrera RC car falling into the water. Avoid running on courses which
are laid exclusively with sand.
Do not expose the Carrera RC vehicle to direct sunlight. To avoid the
G
electronics in the car overheating, when temperatures are above 35 ° C,
regular short pauses in operation are essential.
Never subject the Carrera car to repeated changes of load – that means
H
continuously reversing it.
Always place the car on the floor by hand. Never throw the car on the floor
I
from a standing position.
Avoid jumping from jumps or ramps higher than 5 cm (0.16 ft.).
K
Never use strong solvents for cleaning the car.
L
To avoid malfunctions to the control system resulting in uncontrolled oper-
M
ation of the Carrera RC vehicle, check that the controller batteries and the
rechargeable batteries in the vehicle have sufficient charge. Supply termi-
nals are not to be short-circuited.
The Carrera RC vehicle must be inspected before and after operation, each
N
time it is used, to ensure that it has not become disassembled. Any screws
or nuts that may have become loosened during operation must be tightened.
Instruction Manual
Contents of package
1 x Carrera RC Vehicle
1
1 x Controller
1 x USB charger cable
1 x LiFePO
rechargeable battery
4
1 x Set of batteries (non-rechargeable)

Charging the rechargeable battery

Take care only to charge the LiFePO
2
charging unit (USB charger cable) also supplied. If you attempt to re-
charge the battery with any other LiFePO
charger, this may result in serious damage. You can recharge the rechargea-
ble battery with the respective USB charger cable from a computer USB port
(USB 3.0) or a USB power supply unit with at least 1A output voltage:
• Connect the USB charger cable with the USB port of a computer
LED on the USB charger cable lights green and indicates that the charger is
correctly connected to the computer. When you connect an empty recharge-
able battery, the LED on the USB charger cable goes off and indicates that
the battery is being charged.
reversed polarity is not possible.
• It lasts about 50 minutes to recharge a discharged (NOT a deep-discharged)
battery. When the battery is fully charged, the LED display on the USB
charger cable lights green again
Always recharge the battery after use to prevent its becoming deep discharged.
After use, the battery must be allowed to cool down for at least 20 minutes be-
fore it can be fully recharged. Failure to observe thispause may damage the
battery. Recharge the battery occasionally (suggested every 2–3 months). Fail-
ure to treat the battery as described above can lead to its becoming defective.
Installing the rechargeable battery
Using a screwdriver, remove the cover of the battery compartment in the
3
Carrera RC car. Connect the end of the cable from the Carrera RC vehicle
with the charged battery. Put the battery in place. Replace the compartment cov-
er using a screwdriver.
battery supplied with the LiFePO
4
battery charger or any other type of
4
The USB charger cable is so designed that

Inserting the batteries

Open the battery compartment with a screwdriver and insert the batteries
4
in the remote control. Please keep in mind the correct polarity. Different
types of batteries or new and used batteries are not to be mixed. After having
closed the compartment you can check all functions of the remote control with
the help of the power-switch on the front. With the power-switch turned ON and
proper functioning, the top center LED on the remote control will light up red.
Now you can drive the car
Bonding vehicle and controller
The Carrera RC car and the remote control are bound as a factory setting.
Switch the car ON at the ON/OFF switch.
5
Switch on the controller at the ON/OFF switch.
6
Wait a couple of seconds until the controller and the vehicle have con-
7
nected. The binding procedure is complete when the vehicle moves
slightly.
Let's practise!
Warning! This vehicle reaches speeds up to ~20 km/h (~12.4 mph).
8
Practice on an empty surface at least 4 x 5 metres (13.12' x 16.4'). When
first starting, be very careful when operating the gas pedal.
Now it's time to practise! Set up a Carrera RC vehicle racing track in a large
9
empty area, using cornerposts, empty cans, or similar objects. The basic
technique to adopt when operating a Carrera RC is to drive fast on the straight
sections and to slow down in the curves.
• When changing from the first battery to the second battery, you must
stop running for at least ten minutes. At the next change, a pause of at
least 20 minutes is absolutely essential.
• Avoid constant motor operation.
• If the car switches itself off several times one after another, the battery
is dead. Please recharge the battery.
• Within approx. 30 minutes of inactivity, the controller and vehicle
switch off automatically. To restart, switch the ON/OFF switch on the
controller & the car to OFF and then back to ON.
• To switch off after use, follow the steps in the reverse order.
• After use, remove or disconnect the battery. Always recharge the bat-
tery after use to prevent its becoming deep discharged. After use, the
battery must be allowed to cool down for at least 20 minutes before it
can be fully recharged.
• Always keep the rechargeable battery stored outside the vehicle.
• Clean the Carrera RC car after use.

Controller functions

Differential Steering
10
You can use the joysticks to carry out precise steering and driving manoeuvres.
4
Joystick left and right: Forwards and backwards with steady movement of
left and right joysticks at the same time.
Steer the car to the left by pushing the right-hand joystick forwards and releas-
ing it again. Steer the car to the right by pushing the left-hand joystick forwards
and releasing it again.
. The
360° turn
11
By moving both joysticks slowly and steadily up and down in opposite di-
rections the vehicle can be made to rotate 360 ° on the spot.
Lateral drifting
12
Press button
, to make the vehicle drift to the right. Press button
1
make the vehicle drift to the left.
Drift action
13
Use the 4 arrow buttons
vehicle in the respective direction by continuously pressing the corresponding
arrow button.
On-road and off-road mode
14
7
Press button
, to lift or lower the vehicle's chassis.
Thanks to 2.4 GHz technology, up to 16 cars can be run together on one
15
race-track. This is possible even without harmonising frequencies be-
tween the racing drivers.
5
ENGLISH
3 4 5 6
to operate the drift action. Drift the
2
, to

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis