Set The Water Temperature; Checking The Parameters - COMFORTPOOL EasyHeat serie Benutzer- Und Instandhaltungshandbuch

4.3.

Set the water temperature

directly to adjust water temperature (range: 10 – 42°C).
Press or
Press shortly to save the setting, then exit.
Attention! The heat pump can only run if the water is circulating / the filtration system is running.
4.4.

Checking the parameters

Press to check the parameters, press
will show the measured value. Lastly, press
Code Parameter
d0 Ambient temperature
Outlet water
d1
temperature
Returning water
c0 temperature setting
value
Temperature difference
c1
for restart activation
c2 Auto restart
High temperature
c2
protection
Notice:
1. It is not authorized for end-users to set the parameter data. When needed, please contact your supplier.
2. The required specifications of the sensors are: 50K for high temperature sensor and 5K for others. If these
have to be replaced, you must bear in mind that the same specification must be selected, otherwise they will
not be compatible with the PCB.
or to choose the code d0 or d1, press
to exit.
Scope Default setting
0-99°C
0-99°C
10-42°C 27°C
1-10°C
0-1 min 1 min
50-80°C 75°C
Actually measured value
2°C
0 - not, 1 - activated
32
again and it
Remarks
Adjustable
Adjustable:
Adjustable