2.2.
Initial operation
In order to heat the water in the pool (or hot tub), the filter pump must be running to cause the water to
circulate through the heat pump. The heat pump will not start up if the water is not circulating.
2.3.
Hose connection
Step 1: Install the hose clamps.
Step 2: Connect the hoses to the heat pump.
The 2 pieces of hose and 2 clamps are included in the
accessories package. The upper connection on the
right-hand side of the heat pump is for water outlet and
the lower connection is for water inlet.
2.4.
Electrical connection
Before connecting the unit, verify that the supply voltage matches the operating voltage of the heat pump.
The RCD plug has been included with power cable, which can offer electrical protection against an electrical
shock caused by a possible short circuit inside the unit.
Step 1
Step 2
28