PROTEOR 1P50-R Zusammenbau- Und Justieranleitung Seite 7

CONNECTION WITH OTHER PROSTHETIC MODULES :
Connection in upper part with any Proteor standard module for knee linking, and in lower part with any SACH or DYNASTEP foot
from PROTEOR range.
USE :
For patients up to 100 kg, and for any activity level.
I : PACK CONTENTS (Fig.1)
A Carbon frame
B Hydraulic unit
C Rod
D Upper joint
E Lower joint
F Hexagonal hollow screw
with cylindrical head (x 4)
G Spacers (x 4)
G1 Plain washer
G2 Spring Grower
H1 Hexagonal hollow screw
with cylindrical head
M10x30
H2 Hexagonal hollow screw
with cylindrical head
M10x45
H3 Hexagonal hollow screw
with cylindrical head
M10x60
K Toll for rod reinstallation
Z
Tool for locking in rotation
CAUTION :
1) When cutting and assembling, never modify the position of the green knob of the hydraulic unit.
2) The cutting block ref. 1 P 5070 must IMPERATIVELY be used for adjusting the length of the frame and that
of the rod. PROTEOR cannot be held liable if the Hydracadence frame is incorrectly cut.
3) The hydraulic unit is sealed up. Removing the seal voids the warranty (do not dismantle or lubricate).
II : CHECK THE SCREW FITTINGS FOR THE FOOT
Feet references 1A111, 1A112, 1A118, 1A128 and 1A21 : (Fig.2)
- Spring Grower G2
-Screw H2 (M10x45)
ASSEMBLY AND ADJUSTMENT INSTRUCTIONS FOR 1P50 - R
Fig. 1
K
E
Fig. 2
PROTEOR S A
6 rue de la Redoute - 21850 Saint-Apollinaire - France
Tél. 33 (0) 3 80 78 42 10 - Fax 33 (0) 3 80 78 42 15
ht.orthopedie@proteor.com - www.proteor.com
1P5099-R-1113 7/21