Error Messages; Resetting The System; Setting The Key Lock; Using The Language Code List - Pioneer XV-DV363 Bedienungsanleitung

10 Additional information
Problem
Color problems occur
with your monitor after
changing the HDMI
Color setting (page 27).

Error Messages

Message
LINE ON
EXTRAPWR
SND. DEMO
CANNOT
MUTING
STEREO
TRAYLOCK
KEYLOCK
USB ERR
HDMI ERR
EEP ERR
EXIT

Resetting the system

Use the front panel controls to reset all system
settings to the factory default.
With the system on, press  STANDBY/
•
ON while holding down  USB.
The next time you switch on, all the system
settings should be reset.

Setting the Key Lock

You can disable the front panel buttons by
switching the Key Lock feature on.
1 With the system in standby, press SETUP
and use / to choose KEYLOCK then press
ENTER.
This is shown in the front panel display.
44
En
Remedy
• Depending on the connected equipment, some HDMI Color settings may cause
the picture to be displayed incorrectly. In this case, use the TV's own video input
settings to select RGB, if possible. Alternatively, revert to the previous HDMI Color
setting.
Description
• An operation is prohibited because the Line Out mode is on (page 33).
• You cannot adjust SFC Modes or tone controls (bass, treble, and bass boost)
when using EXTRA PWR mode.
• The sound demo is on. See General in Troubleshooting on page 41.
• An operation is prohibited because DVD/CD or USB isn't selected, headphones
are connected, or TEST TONE is pressed during disc playback.
• An operation is prohibited because the sound is muted (press MUTE).
• An operation is prohibited because the DVD/CD or USB function isn't selected.
• The tray lock is on. See General in Troubleshooting on page 41.
• The key lock is enabled. See Setting the Key Lock below.
• See Important in Using the USB interface on page 23 for more on this.
• See HDMI connection above for troubleshooting tips. See also Resetting the
HDMI connection on page 34 if the problem persists.
• Contact your Pioneer authorized service center or your dealer for servicing.
• Appears when a menu is automatically exited after a set period of inactivity.
Use / to select LOCK ON or LOCK OFF
2
then press ENTER.

Using the language code list

Some of the language options (see Language
settings on page 28) allow you to set your
preferred language from any of the 136
languages in the Language code list below.
1 Select 'Other Language'.
Use / to select either a code letter or
2
a code number.
Use / to select a code letter or a code
3
number.
See the Language code list below for a
complete list of languages and codes.