First Steps With Windows 7 - Omnitronic M-80 Bedienungsanleitung

_______________________________________________

First Steps with Windows 7

1
The first time you connect the microphone to a USB port
it will be recognized as a USB audio device under the
name "OMNITRONIC M-80" and Windows 7 will install
the universal drivers. Windows 7 will display a
notification informing you that the hardware was
successfully installed.
• The notification will not appear next time you plug it in,
as the drivers are already installed.
2
To set the microphone as your default device for sound
playback and recording, or to change its settings,
access the Control Panel and then click Sounds.
Under the Playback and Recording tabs, you can
select the microphone from the menus and use the Set
Default button to set it as the default device.
3
To set the gain of the microphone, make sure it is
selected in the Recording tab and click the Properties
button (fig. 7). Under the Levels tab, moving the slider
will adjust the analog amplifier circuitry in the
microphone (fig. 8).
4
To set the direct monitoring level or the playback
volume in the headphones, click the Properties button
in the Playback tab (fig. 9). Use the Speakers slider to
adjust the headphone level.
• You can also use the buttons ▲ and ▼ on the
microphone to adjust the volume.
• If you select any of your computer's internal sound
cards as the output device, the buttons ▲ and ▼ will
adjust the volume of the sound card.
5
To turn off the zero-latency direct hardware monitoring
(if you want to use software play-through with effects
instead), click the Mute button (speaker symbol) in the
right of the Microphone section (fig. 10).
10/12
(Fig. 7)
(Fig. 8)
(Fig. 9)
(Fig. 10)
00072256.DOC, Version 1.0