Commissioning And Testing; Conversion To Other Types Of Gas; Replacement Of Injectors For Main Burners; Replacement Of Injectors For Pilot Burner - TECNOINOX BS80FG7 Installationswartungs Und Gebrauchshandbuch

Once all the connections have been made, the appliance and the overall installation must be checked
following the directions given in this manual.
Check in particular:
That the protective film has been removed from the external surfaces;
that connections have been made in accordance with the requirements and directions indicated in
this manual;
that all safety requirements in current standards, statutory regulations and directives have been met;
that the water and gas connections are leak-free;
that the electrical connection has been performed according to standards.
Now the appliance can be ignited following the instructions for use and controlling the following points:
- Progressive ignition of the burner;
- even flames;
- flame security: check these points at both minimum and maximum output.
Check that the flue gas exhaust is not clogged and that they are expelled without any hindrance.
The test report must be completed in full and submitted to the customer who should then sign in
acceptance. With effect from this moment, the appliance is covered by the manufacturer's warranty.
- To adapt the appliance to another type of gas, for instance from G20 to G30, it is necessary to control if
the main burner injectors and the by-passes of the gas tilting bratt pans have been installed properly; in
addition, it is also necessary to replace the oven pilot burner injector (see table 3 "Technical Data").
- All the injectors needed for the different types of gas are contained in a bag supplied with the appliance.

2.5.1. REPLACEMENT OF INJECTORS FOR MAIN BURNERS

- To reach the injectors, remove the control panel after having removed the knob of the water inlet tap and
the handwheel vat tilting.

2.5.2. REPLACEMENT OF INJECTORS FOR PILOT BURNER

- Unloose the screw (E), replace the injector (D) with an appropriate one (see table 3).
- With a size 12 key unscrew the injector and replace it with a suitable one (see table 3).
Control the correct distance "H" for primary air (see paragraph "Control of primary air flow").
-
ATTENTION !:After each conversion the appliance must be controlled to make sure that there are
no leakages and that it operates correctly.
Manuale d'istruzione per l'installazione, la manutenzione e l'uso
Brasiere a gas ribaltabili BS80.G7 / BS8.G7

2.4. COMMISSIONING AND TESTING

2.5. CONVERSION TO OTHER TYPES OF GAS

05.11.02 pagina 56