Control Of The Gas Inlet Pressure; Control Of Primary Air Flow; Control Of Pilot Burner; Operation Control - TECNOINOX BS80FG7 Installationswartungs Und Gebrauchshandbuch

- The feed pressure is measured using a liquid pressure gauge (eg. a U shaped pressure gauge, minimum
definition 0.1 mbar).
- Unloose or remove the pressure intake screw
- Connect the U shaped pressure gauge
- Start the appliance according to instructions
- Measure the inlet pressure
- Disconnect the U shaped pressure gauge
- Tighten the seal screw
Warning! The sealed adjuster screws on the gas solenoid valve must not be
tampered with, otherwise any guarantee rights shall be forfeited
immediately.
- Primary air can be considered correctly adjusted if no flame lift is ensured when the burner is cold and
the injector lights when the burner is hot.
- The distance recommended for primary air regulation is indicated in table 3.
- Start the pilot burner according to instructions. If the pilot is adjusted correctly, the ignition flame will
contact the thermocouple evenly and the flame will have a perfect appearance. Otherwise it is necessary
to check if the correct injectors have been installed (see table 3).
- Start the appliance according to instructions for use.
- Control that the appliance does not leak.
- Control combustion safety in the regulation range by passing from maximum to minimum
- Control that the regulation of the pilot flame is correct (use of correct injectors).
- Control progressive ignition and correct regulation of main burner flames.
Manuale d'istruzione per l'installazione, la manutenzione e l'uso
Brasiere a gas ribaltabili BS80.G7 / BS8.G7

2.3.1. CONTROL OF THE GAS INLET PRESSURE

2.3.2. CONTROL OF PRIMARY AIR FLOW

2.3.3. CONTROL OF PILOT BURNER

2.3.4. OPERATION CONTROL

05.11.02 pagina 55