Preparations; Setting Up The Appliance; Assembling/Dismantling The Appliance - Silvercrest SOPE 650 A1 Bedienungsanleitung

Preparations

Setting up the appliance

♦ Before using for the first time, clean all parts as described in the section
"Cleaning".
♦ Place the appliance on a stable, level, dry surface near an easily-accessible
mains socket. If necessary, press the appliance down slightly to fix it to the
surface with the suction cups.
♦ Assemble the appliance as described in the section "Assembling/dismantling
the appliance". If necessary refer to the illustrations on the fold-out page as
well.
♦ Place the filter
on the container
♦ Place the pulp and oil containers
♦ Plug the mains cable
In order to prevent one of the safety appliances from being triggered, do not
connect the mains plug to the mains socket until the appliance has been filled
and the lid
The appliance is now ready for use.

Assembling/dismantling the appliance

NOTE
► The appliance cannot be started if the lid
correctly assembled and the
Assembling the appliance
♦ Move the swivel arm
♦ Open the lock
the
♦ Push the press screw
and insert both into the mounting in the motor unit
press screw housing
Note that the press screw
mounting if the press screw
part with the sealing ring must be about 5 mm deep inside the housing
the screw connection at the lower end of the press screw
completely.
│ GB │ IE
■ 28
on the oil container
lie in the recesses on the filter
into the mains connection
on the funnel
to the highest position.
on the press screw
symbol.
as far as possible into the press screw housing
must face upwards.
in such a way that the two latches
under their respective outlets
has been closed.
and the funnel
press screw lock
by pushing it in the direction of
and housing can only be inserted into the
is correctly inserted into the housing
.
.
in the motor unit .
are not
is not correctly closed.
. The opening of the
. The
;
protrudes
SOPE 650 A1