Installation - S&P EB-100 Bedienungsanleitung

ENGLISH
EB Centrifugal Extractors
The EB range extractors have been ma-
nufactured to the rigorous standards of
production and quality as laid down by
the international Quality Standards ISO
9001. All the components have been
checked and all the final products have
been tested at the end of the manufac-
turing process.
Please read this instructions booklet ca-
refully before installing or starting up the
product. It contains important informa-
tion on personal and user safety measu-
res to be followed while installing, using
and carrying out maintenance work on
the equipment.
Important information
- Check that the apparatus is in perfect
condition while unpacking. Any fault
or damage caused in origin is covered
by the S&P guarantee. Please make
sure that the apparatus coincides with
the product you have ordered and that
the details on the instructions plate
fulfil your necessities.
- Installation must only be carried out by
qualified persons.
- Make sure that the installation com-
plies with each country's current me-
chanical and electrical norms.
- If a ventilator is going to be installed
to extract air from premises where a
boiler or other combustion apparatus
are installed, make sure that the buil-
ding has sufficient air intakes to assu-
re adequate combustion.
- The extractor outlet must not be con-
nected to a duct used to exhaust
smoke or fumes from any appliance
that uses gas or any other type of fuel.
- This appliance can be used by chil-
dren aged from 8 years and above and
persons with reduced physical, sen-
sory or mental capabilities or lack of
experienceand knowledge if they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved.
- Children should not play with the pro-
duct.
- Cleaning and user maintenance shall
not be made by children without su-
pervision.
- Do not introduce any object through
the protective grille.
- Do not remove the front grille while the
fan is in operation or rotation. The ex-
tractor must always operate with pro-
perly mounted front grille.

Installation

IMPORTANT: Before installing and wi-
ring the EB, ensure that the main supply
is disconnected.
Fig. 1
1: Protection grille
2: Fixing screw
3: Fan support
4: Connection terminals cover
5: Cable entry
6: Slot
The EB can be wall or ceiling moun-
ted, and it can discharge directly to the
outside or through a duct (individual or
common duct, Fig. 2).
The hole to be made in the wall or the
ceiling must be 105 mm in diameter.
Loosen the screw (2) fixing the protec-
tion grille (1).
If the installation is made to an individual
ducting, use standard ducting of 100
mm diameter. Smaller diameter must
not be used. If it is necessary to bend
the duct at the discharge of the fan,
make the radius as large as possible.
Before fixing the fan support (3), ensu-