Electrolux TK SL 3E Benutzerinformation Seite 82

82 electrolux
If the water reservoir is full, an active pro-
gramme will break off automatically and the
empty container
light up. In order to continue the pro-
gramme, the water reservoir must first be
emptied.
Warning! The condensed water is not
suitable for drinking or for preparing
foodstuffs.
1.
Take out water reservoir completely.
2.
Pour condensed water out into a basin
or similar receptacle.
3. Refit water reservoir.
If the programme has been interrupted
as a result of the water reservoir being
full: Press the START PAUSE button to
continue the drying cycle.
The water reservoir has a volume of ap-
prox. 4.5 litres. This is sufficient for
around 8 kg of laundry which has previ-
ously been spun at 1000 revolutions/
minute.
The condensed water can be used as
distilled water, e.g. for steam ironing.
However first filter the condensed wa-
ter (e.g. with a coffee filter) to remove
any residue and small pieces of fluff.
icon on the display will
Cleaning heat exchanger
If the heat exchanger
the heat exchanger needs to be cleaned.
Caution! Operating when the heat
exchanger is blocked with fluff can
damage the dryer. This also increases
energy consumption.
1. Open door.
2.
Open door in plinth. To do this, press
the release button on the bottom of the
door aperture and open the door in the
plinth to the left.
3. Clean fluff from the inside of the door
and the heat exchanger front chamber.
Wipe the door seal with a damp cloth.
4.
Turn both lock washers inwards.
5.
icon is displayed,