Drying Rack - Electrolux TW SL EEV Benutzerinformation

Setting child lock
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child lock function locks all
buttons and the programme dial. The child
lock can be activated or deactivated by
holding down the Long anti-crease (Knitter-
schutz Plus) and Buzzer (Signal) buttons at
the same time for 5 seconds.
– Before programme is started: Appli-
ance cannot be used
– After programme is started: Pro-
gramme in operation cannot be
changed
The padlock symbol
play to indicate that the child safety device
is activated.
The child safety device is not deactivated
once the programme comes to an end.
If you want to set a new programme, you
must first deactivate the child safety device.
Starting the programme
Press the Start / Pause button (6). The pro-
gramme is started.
The programme progress is shown in LCD
by appropriate set of icons. From left to the
right, from iron dry
icon depends on the drying cycle chosen.
E. g. in case of cupboard dry programme
the following status icons are visible:
. Current cycle progress is
marked by flashing dash under status icon.
When appropriate part of drying cycle is ac-
complished dash becomes steady and ap-
pears flashing under next status icon.
Changing programme
To change a programme which has been
selected by mistake once the programme
has started, first turn the programme selec-
tor to Off (Aus) and then reset the pro-
gramme.
The programme cannot longer be
changed directly once the programme

DRYING RACK

Special equipment for gentle drying washa-
ble woollens and sport shoes. Incompara-
appears in the dis-
to anti-crease
has started. If nevertheless there is an
attempt to change the programme on
the programme dial, the programme
progress display and the maintenance
indicators flash. If an option (excluding
the buzzer ) is set, Err appears in the
multidisplay. The drying programme is
not however affected by this (laundry
protection).
Programme complete / Laundry
unloading
Once the drying cycle is complete, display
shows a blinking
icon appears dash. If the buzzer option has
been set, an acoustic signal sounds inter-
mittently for about one minute.
The drying (without Wool (Wolle) pro-
gramme) are automatically followed by
an anti-crease phase which lasts
around 30 minutes. The drum rotates
at intervals during this phase. This
keeps the laundry loose and free of
creases. The laundry can be removed
at any time during the anti-crease
phase. (The laundry should be taken
out towards the end of the anti-crease
phase at the latest to prevent creases
from forming.) If long anti-crease
option has been set, the anti-crease
phase is lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove
fluff from the micro-fine filter. It is best to
use a damp hand for this purpose. (See
"Care and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme dial to Off (Aus) .
Important! After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Care and cleaning".)
5. Close the door.
ble for drying wet woollens - eliminated
movement, protection from matting.
electrolux 69
, under anti-crease