Electrolux TW SL EEV Benutzerinformation Seite 63

Door reversal
Warning! Before changing the door
stop, disconnect the mains plug.
1.
A
A
Open loading door.
2. Unscrew hinge A from the front of the
machine and take off the loading door.
3. Remove cover plates B. To do this, in-
sert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block C from
the snap-on fixture, take out and re-in-
sert on the other side having rotated
the block through 180°.
5. Unscrew hinge A from the loading
door, rotate through 180°, re-insert on
the opposite side and screw down.
6. Re-insert cover plates Bon the oppo-
site site having first rotated them
through 180°.
7.
D
E
E
D
Unscrew cover plates D from the front
of the machine, rotate through 180°,
screw on the opposite side.
8. Unscrew door lock E, push down
slightly and remove from the front of
the machine.
9. Press snap-in button F in and down,
press cover down slightly and remove
from front of the machine.
10. Change door lock E over to the oppo-
site side, screw down the door inter-
lock.
11. On the other side, insert cover F and
12. Insert loading door and hinges into re-
B
Note regarding contact protection: The
machine is only secure for operations again
once all plastic parts have been inserted.
C
Special accessories
B
• Stacking kit
• Draining kit
F F
• Pedestal with the drawer
allow snap-in button to lock into place.
cesses on the front of the machine and
screw down.
These intermediate installation kits can
be used to arrange the dryer and a wash-
ing machine (60 cm wide, front loaded)
as a space-saving washer/dryer stack.
The washing machine is at the bottom
and the dryer is at the top.
Read carefully the instructions supplied
with the kit.
Available from your Service Force Cen-
tre or your specialist dealer
Installation kit for direct draining of the
condensed water into a basin, siphon,
gully, etc. The water reservoir then no
longer has to be drained, it must however
remain in its intended position in the ma-
chine.
Fixed hose has to be on the suitable
height from minimum of 50 cm to maxi-
mum of 1 m from floor level and cannot
be looped. If possible shorten the drain-
ing hose.
Read carefully the instructions supplied
with the kit.
Available from your Service Force Cen-
tre or your specialist dealer
To situate the dryer at the optimal height
and have some additional space to store
(e.g. laundry).
Read carefully the instructions supplied
with the kit.
Available from your Service Force Cen-
tre or your specialist dealer
electrolux 63