Electrolux Service 7000 Bedienungsanleitung Seite 60

60
Laundry loading
1.
Open loading door:
Use force to push against the loading
door (push point)
2. Load your laundry (do not force it in).
Caution! Do not jam laundry in be-
tween the loading door and rubber seal.
3. Close loading door securely. Lock must
audibly lock.
Selecting the programme
Use the programme selector to set the pro-
gramme you require. The estimated time to
end of the programme appears on the
LCD, e.g. ( hours . minutes ).
During the cycle, time elapses by steps of
one minute.
Dryness (Trockengrad)
Increases the dryness of the dried laundry
adequately to the selected level:
, . This option helps to achieve
satisfying result of drying.
- default dryness level.
Spin Speed (U/Min)
Shorten the drying cycle adequately to the
spin speed the laundry was spun previously
in the washing machine. The higher spin
speed was, the shorter drying cycle length.
Available spin speed values (rpm): from
up to
This option allows to save time and energy.
Long Anti-crease (Knitterschutz Plus)
Prolongs standard anti-crease phase at the
end of the drying cycle to 90 min. When ac-
tive the symbol
to keep laundry free from creases. Laundry
can be removed at any time during the anti-
crease phase.
Buzzer (Signal)
Audible confirmation of:
– cycle end
– anti-crease phase start and end
– cycle interruption
– error
When active the symbol
Time (Zeitwahl)
Operates only with Time Programme (Zeit-
programm) . Allows to set individual time of
drying from minimum 10 min. to maximum
of 3 hours (in 10 min. steps).
1. Turn the programme knob to the Time
Programme (Zeitprogramm) .
2. Press the Time (Zeitwahl) button repeat-
edly until the desired programme dura-
tion is shown in the display, e.g.
for a programme of 1 hour and 20 mi-
nutes.
Delay Start (Zeitvorwahl)
Allows to delay the start of a drying pro-
gramme from minimum of 30 min. to
maximum of 20 hours.
1. Select the drying programme and addi-
tional options.
2. Press the Delay Start (Zeitvorwahl) but-
ton repeatedly until the desired delay
,
start is shown in the display, e.g.
the programme has to start after 12
hours.
(with 200 rpm steps)
is on. This option helps
is on.
if