Electrolux EQH4512BOG Benutzerinformation Seite 73

Problem
comes on.
and a number come
on.
comes on.
comes on.
comes on.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
Possible
No cookware is on the
cooking zone.
The cookware is incorrect. Use the correct cookware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
The cookware does not
cover the square.
There is an error in the ap-
pliance.
The electrical connection
is incorrect. The supply
voltage is out of range.
There is an error in the ap-
pliance because a cook-
ware boils dry. The over-
heating protection for the
cooking zones and the
Automatic Switch Off op-
erate.
The cooling fan is blocked. Check if objects block the
The electrical connection
is incorrect. The appliance
is connected only to one
phase.
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
ENGLISH
Remedy
Put cookware on the
cooking zone.
Use cookware with cor-
rect dimensions.
Cover the square fully.
Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If comes
on again, speak to the
service centre.
Speak to a qualified elec-
trician to check the instal-
lation.
Deactivate the appliance.
Remove the hot cook-
ware. After approximately
30 seconds, activate the
cooking zone again. If the
cookware was the prob-
lem, the error message
goes out of the display,
but the residual heat indi-
cator can stay. Let the
cookware become suffi-
ciently cool and refer to
"Cookware for the induc-
tion cooking zone" to see
if your cookware is com-
patible with the appliance.
cooling fan. If the error
message comes on again,
speak to the service cen-
ter.
Connect the appliance as
you see it on the connec-
tion illustration.
73