Media Eject Button; Initial State; Rear View; Ac Power Socket - Dell PowerConnect W-650 serie Installationsanleitung

Media Eject Button

The W-650 Series is equipped with a media eject button, which allows users to eject storage devices safely and
place the system in standby. When the button is pushed, the all storage media devices attached to the controller
via USB is unmounted. Printers and EVDO devices are unaffected.
Pushing the media eject button changes the state of the W-650 Series; the table below describes the states and
LED behaviors associated with use of the media eject button.
Table 2
Media Eject Button LED Behavior

Initial State

NAS Media Operational
NAS Media Unmounted
Operational
Operating with NAS Media
un-mounted
Standby

Rear View

Figure 5

AC Power Socket

The W-650 Series supports integrated AC powering and the AC power socket on the rear of the unit is for use
with an AC power cord (country-specific). Refer to
details.
10 | About the W-650 Series Controller
LED State Action
Green-solid Press and hold media
eject button for 1 to 5
seconds only
Amber-solid Press and hold media
eject button for 1 to 5
seconds only
Green-solid Press and hold media
eject button for more
than 5 seconds only
Amber-solid Press and hold media
eject button for more
than 5 seconds only
Red-solid Press media eject
button
W-650 Series Rear View (651 Shown)
AC Power Socket
Status LED
Amber-flashing Un-mount all NAS
media
Amber-flashing Mount all attached
NAS device, and
return to fully
functional operation
Red-flashing Controller goes into
Standby
Red-flashing Controller goes into
Standby
Amber-flashing Controller wake-up
Antennae Interfaces
(651 Only)
ExpressCard Slot
"Power Specifications" on page 17
Dell PowerConnect W-650 Controller | Installation Guide
LED Action
Function
Completed
Amber-solid
Green-solid
Red-solid
Red-solid
Green-solid
for power specification