Inserting Negatives - Silvercrest SMS 5.0 A1 Bedienungsanleitung Und Serviceinformationen

Inserting negatives

 Open the negative holder at the point marked "OPEN". Then place the negatives in the device as
shown in the following image. Make sure that the negatives are not inserted the wrong way
around or upside down. In this case, you can refer to the numbering on the negative strip. The
perforations of the film strip must engage in the corresponding retaining pins in the negative
holder.
 Close the negative holder.
 Insert the backlight rail, with the reflective surface facing upwards, in the backlight slot [10] until it
noticeably snaps into place.
 Insert the negative holder, with the inscription facing upwards, in the direction of the arrow in the
negative/slide slot [7]. Insert the negative holder in until it noticeably snaps into place in the first
position. For more negatives, insert the negative holder in further until it noticeably snaps into
place in the next position.
 To record the negatives, please read the section "Recording" from page 98.
 Remove the backlight rail and the negative holder after you have recorded your negatives. You
remove the backlight rail by pressing it down lightly on the protruding point and pulling it out.
SilverCrest SMS 5.0 A1
English - 95