Werbung
17
Quick Start Guide
CffiJ
Step 2: Controls
CIJ
RACK EARS secure the unit into a rack using
four attaching screws and washers (fasteners
not included). Requires two rack units.
ITJ
VENTILATION openings allow back-to-front
air circulation to prevent overheating.
CIJ
INPUT CONTROLS adjust the input level.
To increase signal gain, rotate the knobs
clockwise; to reduce the gain, rotate the knobs
counter-clockwise.
CD
SIGNAL, LIMIT and PROTECT LEOs display
the signal level and system status for
each channel. The SIGNAL LEDs light to show
the input signal level. The LIMIT LED lights
when the input signal exceeds an optimum
level and activates the internal limiter.
Reduce the input gain if the red LIMIT LED
lights up continuously. The PROTECT LED
shows when an operation error has occurred
(over current, over temperature, and so on).
When an operation error occurs, the PROTECT
LED will light and the unit will automatically
mute the channel until the error is no longer
detected, after which the PROTECT LED will
switch off and the amp will behave normally.
CD
SETUP button steps through parameters
within DSP processing modules.
Cil
LCD SCREEN displays the current DSP module
and parameter settings.
0
PROCESS button steps through the DSP
processing modules.
CD
UP/DOWN buttons step through
DSP modules.
Cil
EXIT button takes you back to the top-level
DSP screen.
(ill
SELECT encoder knob toggles between
Graphic and Edit modes (when pressed) and
changes parameter values (when rotated).
Gil
POWER button turns the amplifier on and off.
@
INPUTS Route line-level input signals into
@
POWER SOURCE jack accepts the included IEC
power cable.
Gil
OUTPUTS connect the amplifier to the
speakers using professional speaker cables
with twist-locking plugs.
(ill
PIN OUT MATRIX lists the output pin/channel
configurations available in each speaker
output jack.
(ill
VENTILATION FAN speed adjusts
automatically to ensure trouble-
free operation.
these combination jacks using XLR,
balanced W' TRS, or unbalanced
W'
TS connectors.
(ill
USB connection enables firmware updates
and control over parameters via computer.
Please visit behringer.com to download DSP
control software for your computer. The USB
port is for amplifier configuration only.
@J
BREAKER (automated fuse, NX6000D).
After eliminating the cause of faulty
operation, simply depress the BREAKER and
power up the unit again. The BREAKER acts in
place of common discardable fuses.
BREAKER WARNING: Take the following actions
BEFORE resetting the breaker:
• Unplug the AC main cable
• Press the POWER button to the extended
"OFF" position
• Turn all input gain control elements down
• And then, reset the breaker, connect the unit to
the mains, switch ON and slowly increase the gain
to the target volume
Werbung
