Model Assembly; Wing Installation - Modster Arrows HOBBY 980mm P-47 Bedienungsanleitung

Model assembly

Wing installation

1. Attach the wing onto the fuselage, ensuring not to
pinch any of the servo wires.
2.Attach the wing to the fuselage with included screws as
shown. Do not over tighten the screws.
Horizontal stabilizer installation
1.Slide the horizontal stabilizer spar into the slot near the rear of the fuselage.
2.Install the two pieces (left and right) horizontal stabilizer as shown. Ensure the control horn faces down.
3.Secure the two horizontal stabilizer pieces in place using the included screws.
4.Attach the ball link to the elevator control horn.
Pitot tube installation
1. Carefully apply foam safe CA to the base of pitot tube and
place the pitot tube into the pocket as shown.
2.Carefully apply foam safe CA to the foam block and place
the foam block into the cut-out.
KA2.6*12mm
Required Adhesives:
Medium CA
HKM3.0*32mm
04