Technical Specifications; Battery Charging - Seac Sub Lighthouse Anweisungen

ENGLISH
GENERAL WARNINGS
• Never keep the torch on when out of the water.
• Do not direct the light towards the eyes both under water and out of the water.
• Never unscrew the torch front or back during a dive or if wet.
• Do not keep the torch near extreme heat sources.
N.B. THE TORCH BATTERIES MIGHT BE FLAT AT THE TIME OF PURCHASE !
• According to the transport regulations in force, the torch must travel with flat batteries.
• You are strongly advised to check the state of batteries before use.
• Only the battery charger supplied with the lamp shall be used to charge the batteries.

TECHNICAL SPECIFICATIONS

• Body and metal parts made in anodized anticorodal aluminium with numerical control technology.
• Nickel-Metal hydride (Ni-Mh) rechargeable battery pack.
• Intermediate-beam optics.
• Aluminium metallized Dichroic reflector.
• Shaped aluminium handle with lanyard hole.
• Non-feedthrough rotating magnetic switch with two positions: OFF/ON.
• Regulating knob designed for use with thick underwater gloves. Mechanical lock against accidental switching.
• 12 V - 50 W halogen Xenon bulb.
• Anti-burst valve calibrated to 0.9 bar.
• Twin O-ring fitted at thread end.
• Internal charging socket.
• Max. charging time: 5 hours.
• Multifunctional electronic circuit:
1.Electronic check of battery over-discharge.
2.Constant current regulator check in "Switching" technology.
3.Polarity inversion check.
4.Continuous check of the light output in three phases:
PHASE 1: When 85% consumption is reached, flashing light signals "batteries nearly flat".
PHASE 2: Automatic reduction of the light output (50% of the power for about 3 minutes): "anti-panic effect".
PHASE 3: Automatic cut-out to preserve batteries.
10
SPECIFICATIONS LIGHTHOUSE 50 W
Power 50 Watt
Voltage 14,4 V
Batteries
Amperes
Electronic circuit
Bulb supplied 50 W Xenophot
Body material Anodized anticorodal aluminium
Reflector material Aluminium metallized
Lens 6mm tempered glass
O-Ring
Weight in air 1600 gr
Weight under water 980 gr
Length 265 mm
Diameter 75 mm
Switch Magnetic switch with "Hall" effect
Switch lock Mechanical in LOCK position
Colour temperature 3200°K
Light beam Intermediate
Gas-release valve
Charging socket Internal
Battery charger Automatic
Max. charging time
50 W bulb – up to 50 min
Burntime in minutes
35 W bulb – up to 65 min
Max. depth

BATTERY CHARGING

CAUTION:
- Non observance of these instructions may cause irreparable damage to the battery pack.
WARNING:
- Batteries must be charged using only the battery charger supplied with the lamp.
LIGHTHOUSE 50 W POWERED
50 Watt
14,4 V
Ni-MH Ni-MH
3.5 3.8
YES YES
50 W Xenophot
Anodized anticorodal aluminium
Aluminium metallized
6mm tempered glass
NBR NBR
1600 gr
980 gr
265 mm
75 mm
Magnetic switch with "Hall" effect
Mechanical in LOCK position
3200°K
Intermediate
YES YES
Internal
Automatic
5 h 5 h
50 W bulb – up to 60 min
35 W bulb – up to 80 min
100m 100m
ENGLISH
11