Preparing For Use; Cleaning And Care; Working With The Blender; Technical Data - AEG STM 11 serie Gebrauchsanweisung

Preparing for use

Before using for the first time, it is
3
advisable for reasons or hygiene to
clean the mixing attachment.
Dry the mixing attachment well before
using it.
Inserting/removing the mixing
attachment (Figure 3)
Before inserting or releasing the mix-
1
ing attachment, switch off the blender
and remove the plug from the mains
socket!
0 Insert the mixing attachment to the
motor part and lock it by turning
clockwise.
0 Tor remove, unlock the mixing attach-
ment by turning it anticlockwise.

Working with the blender

The appliance can be used for up to
1
1 minute without stopping. It should
be allowed to cool afterwards for at
least 1 minute.
0 Insert the blender deep into the bowl,
then press switch A (for speed I) or
switch B (for speed II) (Figure 3).
3 Start all types of processing at speed I.
This will avoid powdery foods and liq-
uids spraying out.
Light upward and downward move-
ments of the blender permit the mate-
rial being worked on to be handled in
the best possible way. Please make sure
that:
– the mixing attachment never has
more than two-thirds of its length
immersed in the material,
– the mixing bowl is never more than
two-thirds full (to avoid the danger
of splashes).

Cleaning and care

Remove the plug from the mains
1
socket before cleaning.
Ensure that no water penetrates into
the inside of the appliance! Never
clean the motor part under running
water and never immerse in water.
0 Wipe the motor part with a damp
cloth.
0 Clean the mixing attachment after
each use by holding it in a bowl with
hot water, possibly adding some com-
mercially available washing-up liquid,
and allow the appliance to run for
serveral seconds.
1 The mixing attachment is not to be
washed in a dishwasher!

Technical data

Mains voltage:
Power consumption:
Maximum continuous
operating time:
This appliance complies with the fol-
;
lowing EC directives:
• 73/23/EEC of 19/2/1973 "Low volt-
age directive", including the modifi-
cation directive 93/68/EEC.
• 89/336/EEC of 3/5/1989 "EMC direc-
tive", including the modification
directive 92/31/EEC.
g
230 V
400 W
1 minute
9