English; Before First Use; Getting Started - AEG STM3-Serie Gebrauchsanweisung

ENGLISH

Thank you for choosing an AEG product. In order to ensure the best results, always use original AEG accessories and
spare parts. They have been designed especially for your product. This product is designed with the environment in
mind. All plastic parts are marked for recycling purposes.
COMPONENTS
A. Start button
B. Turbo button
C. Handheld part
D. Metal mixing foot
E. Knife
F. Power cord
G. Beaker
Picture page 2-3

BEFORE FIRST USE

1
Before using your appliance, remove all packing material, plastic, labels, stickers or tags that may be attached to the
motor base, bowls or attachments.
Warning! Never immerse the housing, plug, or cord in water or any other fluid.
Caution! Switch off the appliance and disconnect from supply before changing accessories or approaching parts that
move in use.
2
Wash all parts, except for the motor base, in warm soapy water. Dry each part thoroughly before use.
All parts, except for potato masher foot, whisk adapter and chopper upper part, can be washed on the top rack
of your dishwasher.
3
The housing should only be cleaned with a soft damp cloth, then dried with a cloth.
Note: Do not use abrasive cleansers or scouring pads to clean the surfaces of your appliance.

GETTING STARTED

4
Insert the mixing foot to handheld part, turn clockwise (A) and lock into position. To remove, turn mixing foot
counter clockwise (B).
5
Insert the stick mixer deep into the beaker, begin mixing by starting at normal speed. Make sure the beaker is no
more than 2/3 (600 ml) full. If you do not use the beaker, do not immerse the mixing foot more than 2/3 of its length.
Move stick mixer lightly up and down to ensure best processing of content. Release switch to stop.
6
Using the mini chopper*. Place chopper bowl on a clean, level surface. Put stainless steel blade into place.
7
Place food into the chopper bowl*. Amount of food to be chopped cannot exceed 300 g ( Indicated max level).
Close the lid.
8
Insert handheld part into the chopper lid, turn clockwise (A) and lock into position. Plug into power outlet and
press switch to start. Release to stop. Remove handheld part by turning counter clockwise (B).
9
Working with the traditional whisk*. To assemble whisk with handheld part, turn handheld part clockwise until
tightened. To disassemble, turn counter clockwise.
10
Using the potato masher*. To assemble potato masher with handheld part, turn handheld part clockwise until tight-
ened. To disassemble, turn counter clockwise.
Note: Potatoes are boiled and then smashed at maximum speed during 60 seconds.
www.aeg.com
STM3xxx_ImmersionBlender_AEG NO-FARSI.indd 6
H. Traditional whisk*
I. Chopper bowl*
J. Chopper bowl lid*
K. Chopper bowl knife*
L. Plastic mixing foot*
M. Potato masher*
*depending on model
6
2017-07-06 15:18:25