Kirami Original Easy Gebrauchsanweisungen Seite 23

CULT stoves
The tub needs to be filled at least 5 cm above the upper
connection pipes of the stove before lighting the fire in the
stove (picture on right).
Do not let a full tub freeze in the winter. Empty the tub or
ensure appropriate heating.
Do not connect the stove to the circulation pump. It cannot
ensure the pressure because it is planned only for
gravitational circulation.
SUB LT stoves
The tub needs to be filled at least 35 cm above the upper
connection pipes of the stove before lighting the fire in the stove
(picture on right)- The stove has the marking _MIN_ indicating
the height.
The first use
In external stoves (CULT) the water circulation of the stove
shall be rinsed by letting plenty of water in from the pipe
above, so that any metal chips from grinding come out.
Collect any trash by swiping it off the bottom of the tub. When you fill the tub, check the
fastening pipes of the stove for any leakages.
LIGHTING AND USING THE STOVE
Use small firewood for lighting the fire. Keep the fire in the stove so that the firewood will burn and
the tub will heat with maximum power. The heating will take longer if the fire is not sufficient.
Empty the ashes from the stove after every use, so that the air
slides do not remain inside the ashes, because it will make their life
shorter.
Use only small, dry firewood in the stove. The use of larger
firewood may double the heating time. We do not recommend
black alder because it is sootier than other wood.
Use lighter fluid according to the instructions. Do not use any other
fuels for lighting. We recommend lighting pieces, e.g. Burner
paraffin bags.
Cold water and warm air (temperature difference/air humidity)
often cause condensed water in the ash collector and, therefore,
the stove is not leaking although there is some water in the
furnace. You can suspect a leakage only if the water level is going down.
INSTRUCTIONS FOR USE: Original Easy, for hot tubs
5 / 8
23/60