Kirami Original Easy Gebrauchsanweisungen Seite 20

General
The product is designed for private outdoor use only. The tubs have a frame and transport pallet for
transport. It needs to be removed before the final placement of the tub. In case the tub has been
supplied sideways, it needs to be turned to the correct position as soon as possible so that the tub
does not become oval and the bottom will not come off from the sides.
INSTALLATION
Making the foundation
Place the tub on an even surface that bears the tub weight. The foundation can be levelled with
chips (picture below) or if you want a more solid foundation, it can be cast of concrete. Ensure that
the tub is not covered by grass or hay, as it will prevent the wood from breathing and will cause
rotting. The base in an EPS based tub can be covered by earth, as long as the ends of the side panels
get to breathe.
Fastening the stove
Depending on the model of the product, the stove
is supplied separately or fastened. Internal
SUB/SUB LT stoves are usually fastened at the
factory (excluding special shipments to stores). In
case the product has been supplied on its side
(usually only abroad), the protective fence of
these stoves is separate and it shall be fastened
with the supplied screws. The model-specific
drink holder is attached to the protective fence.
The external CULT stove is delivered
disconnected and there are model-specific
instructions and equipment in the stove package.
Ensure the water-tightness and fastening to the
tub. There is an optional model-specific drink
holder/protective plate through which fastening the stove can be made.
INSTRUCTIONS FOR USE: Original Easy, for hot tubs
2 / 8
20/60