Kirami Original Easy Gebrauchsanweisungen Seite 22

Flue
Be careful, the edges of the chimney are very sharp. Use
protective gloves! The chimney of an external CULT stove is
delivered in a separate box and it consists of four parts (picture on
right) and it needs to be assembled. Remove the protective film
from the thermal protection and place the assembled chimney to
the chimney outlet of the stove.
Only a 1-metre pipe is supplied with the internal SUB LT chimney,
which is installed directly to the stove with the reduced end first.
USE
When filling the tub, note the number of people because people entering the tub will displace the
water when they enter the tub. If there will be many people in the tub, leave the water surface to
the minimum.
The water is layered when it heats up and, therefore, it needs to be mixed so that the actual
temperature can be found. The optional cover should be in place when heating the water. Note that
there needs to be space around the chimney in order to avoid melting the cover. This concerns SUB
LT models where the chimney exits below the tub through the cover.
You can use 19 mm spanners for the outer edge of the hoop tighteners. These
tighteners are used for adjusting the hoops. You do not usually need to adjust
these in a plastic tub, but in case the boards loosen when they dry, the hoops can
be tightened.
In case you are using your own pump for filling the tub, remove the pumping hose after you have
filled the tub. Many pumps do not have a return valve to prevent the water discharge from the tub
when the pumps are switched off. Before filling the tub, check that the bottom plug of the tub is
closed, and ensure that the plug is in place after you have some 10 cm of water in the tub.
Do not leave the water unattended in case there is a risk of subzero temperatures. The bottom
plugs and exhaust valves need to be left open so that any water collected in the tub can be
discharged and it will not freeze at subzero temperatures.
Note about the minimum fill and heating the stove!
The tub stove must never be lit when the tub is empty or not full! Heating a half-empty
tub will lead to melting the stove! You must not start emptying the tub before the fire
and embers have burnt out completely. Heating a half-empty tub will lead to melting the
stove!
The minimum filling information can be found below regarding the stove model:
INSTRUCTIONS FOR USE: Original Easy, for hot tubs
4 / 8
22/60