Sharp KA-72D19AM2-EU Bedienungsanleitung Seite 17

Use the induction cooking zones with
suitable cookware.
After mains voltage is applied, the hob
is in the stand-by mode and it is ready
for operation.
The hob is controlled with knobs for
setting cooking level, controlled with
touch sensors for setting timer.
Each sensor activation is followed by a
sound signal (buzzer).
Switching the cooking-zones on:
Use the related knob to adjust cooking
level from 0 to 9. The element is now
ready to cook on. For quickest boil
times, keep the knob at the P position
for 2 seconds to activate Boost function
and then adjust to the level you wish.
Switching the cooking-zones off:
Adjust the knob to "0".
If the cooking zone is hot, "H" will be
displayed instead of "0".
Residual heat indicator:
Residual heat indicator indicates that
the glass ceramic has a dangerous
touch temperature in the circumference
of a cooking zone.
After switching off the cooking zone,
the respective display shows "H"
until the assigned cooking zone
temperature is in an uncritical level.
Safety switch off function:
Every cooking zone will be switched
off after a defined maximum operation
time if the heat setting is not modified.
Every change in the cooking zone puts
back the maximum operation time to
the initial value of the operating time
limitation. The maximum operation time
depends on the selected temperature
level.
Heat setting Safety switch off after
1-2 6 Hours
3-4 5 Hours
5 4 Hours
6-9 1,5 Hours
Timer Function
Cooking zone timer (1..99 min):
When the hob is switched on, an
independent timer can be programmed
for every cooking zone.
Adjust the level for a cooking zone and
then activate the timer setting key
, the timer can be programmed
as a switch off function for a cooking
zone. Around the timer four LEDs are
arranged. These indicates for which
cooking zone the timer has been
activated.
10 seconds after the last operation,
the timer display changes to the
timer that will run out next (in case of
programming more than 1 cooking
zone).
When the timer has run down, a
signal sounds and the timer display
shows "00" statically, the assigned
cooking zone timer LED blinks.
The programmed cooking zone will
be switched off and the "H" will be
displayed if the cooking zone is hot.
The sound signal and the blinking
of the timer LED will be stopped
automatically after 2 minutes and/or by
operating any key.
Buzzer :
While the hob is in operation, the
following activities will be signalled by
means of a buzzer:
- - Normal key activation with a sho
sound signal