www.heinner.com
CLEANING THE EXHAUST AIR FILTER
The exhaust air filter cleans the air a final time before it leaves the vacuum cleaner. You
can clean the exhaust air filter as follows:
1. Switch off the vacuum cleaner and disconnect the plug from the mains. To do this
always pull on the plug and not on the cable.
2. Open the exhaust air grill (this is at the rear of the cyclone vacuum cleaner.)
3. The exhaust air filter is visible when the grill has been opened.
4. Rinse the filter under cold running water and allow dry.
5. Put the exhaust air filter back into place (or replace with a new one) and place in
the grill.
6. Close the exhaust air filter grill.
700W, 230V~50Hz
5