Heinner HVC-E700GR Bedienungsanleitung Seite 19

www.heinner.com
HOW TO INSTALL DUST BAG
Turn off vacuum and unplug the electrical cord before changing dust bag or cleaning
motor filter. Never operate the vacuum cleaner without the dust bag or filter.
1. Turn off and unplug cleaner.
2. Open bag cover by pushing latch up with fingers and lifting bag cover.
3. Remove motor filter and clean by rinsing under warm water, if heavily soiled. Let
completetely air dry before reinstalling.
4. Open bag folds slightly.
5. Turn off and unplug cleaner. Open bag cover by pushing latch up with fingers and
lifting bag cover. Remove motor filter and clean by rinsing under warm.
6. Place dust bag frame inside dust bag compartment placing dust bag frame into the
guides at the very front of the dust bag compartment.
7. Swing bag cover lid closed and push to latch.
CLEANING THE HEPA FILTER
The HEPA filter and the HEPA cover should be cleaned regularly. Cleaning is best done
when emptying the dust container. To do this follow the instructions in the Emptying
dust container section.

Switch off the vacuum cleaner and disconnect the plug from the mains. To do this
always pull on the plug and not on the cable.

You can pull the dust container together with the cleaning system out of their
anchoring with the aid of the carrier handle on the dust container. Take hold of the
carrier handle on the dust container and pull it upwards. Now pull the dust
container out and loosen the HEPA cover and HEPA filter out of the dust container
with the aid of the lateral unlocking button.

Turn the dust container cover carefully until it is released and the HEPA filter will
come away easily.

Now rinse the HEPA filter under running water and allow it to dry.

Place the HEPA filter back in the HEPA cover (or replace with a new one) and fit it
into the dust container. Then fit the dust container back into position in the cyclone
dust container until it snaps into place. Your cyclone vacuum cleaner is now ready
for use again.
700W, 230V~50Hz
4