RIDGID B-500 Bedienungsanleitung Seite 14

Model B-500 Transportable Pipe Beveller
Figure 17A – Hand Tighten Clamp Screw
Figure 17B – Tighten Clamp Screw Additional
6. Set the desired bevel land width (Figure 18) using
the land width
adjustment gage. If
set to "0" there will
be no land on the
end of the pipe.
Each step on the
land width adjust-
ment gage is ap -
proxi mately a 1 / "
32
(0.8 mm) different
(Shoulder
(Shoulder
from the ad jacent
step. (1 ~ 0.03" (0.8
mm) land width, 2 ~
0.06" (1.6 mm), etc.)
Move the needed
Figure 18 – Land Width
step of the gage so
it aligns under the
head of the stop.
7 . Confirm that the cutter head is fully retracted and not
in contact with the work piece. With dry hands, plug the
12
3/4 Turn
(270°)
3 / Turn (270°)
4
Land Width
Land Width
Adjustment
Adjustment
Gage
Stop Stop
Cutter
Cutter
Feed
Feed
Screw)
Screw)
Screw
Screw
Adjustment Gage
Setting
beveller power cord into a properly grounded out-
let/extension. All indicator lights should be illuminated.
Assume a proper operating position (Figure 19).
• Stand at the back of the machine, facing the hand
crank with good access to the ON/OFF switch. In
case of emergency you must be able to turn the
machine OFF.
• Be sure you have good balance and do not have
to overreach.
Depress the ON button (I). After motor comes up to
speed, yellow indicator lights should be ON.
Figure 19 – Proper Operating Position
8. Using a smooth continuous clockwise rotation of the
cutter feed screw (Figure 18); engage the cutter head
into the work piece until the stop contacts the land
width adjustment gage. Do not use cutting oil or
coolant.
9. Tighten the gib plate locking screw to lock the cutter
head into position (Figure 15). If gib plate locking
screw is not securely tightened, the cutting inserts
could become damaged.
10. Insert the hand crank into the drive shaft or extension.
Using a controlled uninterrupted motion, start rotating
the hand crank in a clockwise direction to bevel
(Figure 20).
It is important to provide proper rotational speed to
prolong the life of the cutting inserts. Monitor the LED
indicator lights on the rear of the unit. Green indi-
cates the proper speed. Yellow indicates that you
need to rotate the handle faster, Red indicates to
rotate the handle slower. (See Figure 21.)
The crank should only turn clockwise when viewed
from the back of the beveller. Do not drive the beveller
with a drill, impact or other power tool – drive by
hand only. Do not use cutting oil or coolant.