Connect Wireless Speakers; Automatic Updates - Canton Smart Soundbar 10 Kurzanleitung

CONNECT WIRELESS SPEAKERS

The Soundbar 10 offers you the possibility to connect up to 7 Canton Smart Spea-
kers wireless to a 5.1.2 home theater set. Before you connect Canton Smart Speakers
to Soundbar 10, please make sure that the Smart Speaker to be newly connected has
been disconnected from the power supply for minimum 10 seconds.
Please go to the main menu by pressing the „M" button. Select Now select the
1
menu item „Wireless Setup" [WIS] and confirm with „OK".
Select the function Pairing of wireless speakers [WSP], confirm with the „OK"
2
button and select the speaker to be connected.
After
„Pairing"
3
plug in the power cord of the (new) speaker to be connected into the power
outlet and turn on the power switch (if present). After successful pairing the
On-screen display shows „connected" and the diplay of the Soundbar 10
as well as the display on the slave speaker indicate [CON].
Note:
• In a wireless home theater set, Soundbar 10 is always the „master speaker,"
and all other speakers are defined as „slave speakers.

AUTOMATIC UPDATES

After you have connected Connect 5.1 to the network, firmware updates are execu-
ted After each connection to the power supply and at regular intervals (also in stand-
by), Connect 5.1 searches for an update and installs it, if available. The LED flashes
green / red during the update and the display first shows „DOWNLOADING", then
„UPDATING". During this time the system is not ready for operation. Do not discon-
nect the Soundbar 10 from the power supply during an update process.
is shown on the TV screen and [PIR] is indicated in the display,
English
3 4 1