Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To find out the code of your remote control, follow this procedure:
1. Press the select key for which you want to know the code
and hold down for 5 seconds.
2. When the key is released it will start to flash; press and
release the 1-/-- key within 8 seconds.
3. After a pause of several seconds, the indicator light produces
four series of flashes with a space between them, corres-
ponding to the code you are looking for. Count the number
of flashes; each series of flashes corresponds to one figure
in the code. 10 flashes correspond to 0.
4. Note the code on the adhesive label inside the battery cover
in case you have to reprogramme the remote control subse-
quently.
NB: this operation cannot be interrupted and the remote control
cannot therefore be used until the end of the four series of flashes.
If you know the exact code with which to programme the remote control, enter it as follows:
1. Hold down the selection key for the appliance to be
programmed for 5 seconds.
2. When the key is released it will start to flash; enter the
code ( e.g. TV 1306 ). Three flashes indicate that the
operation has been completed correctly.
The functions Mute , Vol - , Vol + and AV are memorized on the keys F1 , F2 , F3 , F4 . These functions
can be used to control appliances other than the TV. For further information consult the on-line guide
on the site www.cme.it
HOW TO USE THE ADDITIONAL COMMANDS WHICH DO NOT APPEAR ON THE KEYPAD
Find them on your remote control by pressing the keys one by one and discovering the commands that
interest you.
In particular, the additional functions most frequently used, such as NORMALIZATION, COLOUR and
BRIGHTNESS, can be found on the following keys:
For the functions used less frequently, look for the additional commands on the site www.cme.it. As well
as easily finding the code to programme your remote control, consulting the on-line guide will help you
to find which keys on the remote control correspond to the additional commands. You can memorise the
additional commands on the F1 - F2 - F3 - F4 function keys in place of the corresponding original TV
functions.
CURREN T CO DE DI S PL AY
ENTERING THE CODE
TV FUNCTIONS ALWAYS ACTIVE
Although not indicated on the keypad,
some keys can be used for additional commands.
Normalization:
Brightness (+):
Brightness (-):
Colour (+):
Colour (-):
or
VCR
......................................................... = 1
.............................................. = 3
Code obtained = 1306
or
VCR
1 1
3
+
or
or
or
or
or
5 SEC.
TER
= 0
............................ = 6
or
5 SEC.
TER
0
6
+
+
9
Werbung
Inhaltsverzeichnis
