Fitting The Batteries - CME Control TV 100 Gebrauchsanleitung

GB
The CONTROL TV 100 replacement remote control, thanks to its large database and numerous functions,
Handling is easy thanks to the ergonomic shape. The large keys are easy to see and to use.
Keep this booklet in case you ever need to consult it in the future. For anyone with internet, via the website www.cme.it, it is
even easier and quicker to program the remote control and discover all the potential of the CONTROL TV 100 thanks to the
The functions described below are only available if they are already foreseen by your TV.
Light indicator
Teletext keys
Number keys
Control the volume
using +/-
Key with additional TV functions
Fastext functions or
to select submenus
by means of the colours
The remote control requires 2 new AAA/LR03 batteries. Insert the batteries as shown:
• Change the batteries if the light indicator starts to flash during use. The batteries are low.
• When you remove the batteries, fit the new ones within 5 minutes or you may have to
re-program your remote control.
• Make a note of the code for your TV on the adhesive label inside the battery cover in case
you have to re-program your remote control.
Read these instructions carefully before programming your remote control!
The quickest and easiest way to program the remote control is by consulting the website
1. Switch on the TV.
2. Look for the brand of the television you want to program in the code list and make a note of the corresponding code alongside (e.g. PHILIPS
0025).
3. Hold down the and
being programmed.
4. Release the keys. Within 12 seconds, enter the brand code previously identified (e.g. 0025). The light indicator flashes more quickly to indicate
that the remote control is ready for the search.
5. Point the remote control towards the TV. Press and slowly release the
6. When the TV goes off, press the
CHECK: Check that some of the other functions used on your original remote control are working correctly. If the controls function only
partially or anomalously then the code found is very probably for a similar remote control unit and therefore incorrect. In this case, repeat
the search procedure starting from point 3 by entering the code used previously (e.g. 0025).
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
N.B. THE LIGHT INDICATOR STOPS FLASHING.
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if an invalid brand code is entered
• if the end of the code search list has been reached. In this case visit the website www.cme.it
User instructions
CONTROL TV 100
Thank you for choosing a CME remote control.
is ideal for replacing any lost, defective or broken TV remote control.
on-line guide.
US IN G TH E K EY S A N D FU NC T I O NS
F I TTI N G TH E BATT ERI ES
Before programming and using the remote control, fit the batteries.
P R EPA RE F OR U SE
HOW TO PROGRAMME THE REMOTE CONTROL
keys together for 5 seconds until the light indicator starts to flash indicating that the remote control is
key to confirm. Three flashes indicate that the operation has been completed correctly.
turns the volume on and off
To move around within the MENU
www.cme.it
key several times, stopping when the TV goes off.
TV ON/OFF key
to turn the TV ON/OFF
To select an external input
terminal
MUTE
To select the next (P+) or
previous (P-) channel or
or to control the
BRIGHTNESS/COLOUR
Confirm key
To access the MENU
3