EINHELL BT-KF 150 Originalbetriebsanleitung Seite 32

6.4 Fitting sanding/grinding belts
Fit the sanding/grinding belts (16) to the grinding head (20) as shown in Fig. 5.
6.5 Adjusting the working depth (Fig. 6)
Undo the thumb setting screw (5), move the soleplate (7) to the required working
depth (approx. 3.2 mm more than the material thickness for completely cutting
through the workpiece). The maximum cutting depth for wood is 13 mm. The tigh-
ten the thumb setting screw (5) again.
6.6 Making a plunge cut
Guide the bit into the workpiece at an angle of 45°. Move the bit slowly to an angle
of 90° to start the cut.
Note:
The soleplate must be positioned fl ush in contact with the surface of the material
6.7 Swiveling the handle (Fig. 7)
Press the swivel lock (13). Then move the handle upwards. It locks in the 45° positi-
on fi rst. If you actuate the swivel lock (13) again, you can move the handle comple-
tely up and into the vertical position, where the handle once again locks in position.
To swivel it into the starting position, proceed in reverse order.
6.8 Using the parallel guide (Fig. 8)
Undo the thumb screws (9) on the soleplate (7) and guide the guide rod of the cir-
cular/parallel cutting attachment (15) through the two cutouts on the underside of
the soleplate (7), so that the parallel guide faces downwards. Position the tool at
the required distance to the edge of the workpiece. Tighten the thumb screws (9) in
order to fasten the circular/parallel cutting attachment (15) to the soleplate (7).
6.9 Sawing a circle (Fig. 9)
Note:
The guide hole has to be positioned either on the inside or outside of the edge of
the circle, depending on the desired result: On the inside for a breakthrough and
on the outside for a wheel. The radius can be fi xed at approx. 5 to 16 cm. Draw a
circle on the workpiece. Mark the center of the circle and drill a guide hole (with a
diameter of 3 mm) in the workpiece using a drill. Undo the thumb screws (9) on the
soleplate (7) and guide the guide rod of the circular/parallel cutting attachment (15)
through the two cutouts on the underside of the soleplate (7), so that the centering
tip (21) faces downwards. Insert the centering tip (21) into the center of the circle
and set the distance of the circular/parallel cutting attachment (15) so that the bit
goes into the guide hole at the edge of the circle. Then lock the soleplate (7) by
tightening the thumb screws (9).
Anl_BT_KF_150_SPK7.indb 32 Anl_BT_KF_150_SPK7.indb 32
GB
- 32 -
23.06.2016 09:28:59 23.06.2016 09:28:59