EINHELL BT-KF 150 Originalbetriebsanleitung Seite 25

d) Do not use the cable to carry the electric tool, to hang it up or to pull it
out of the socket. Keep the cable away from heat, oil, sharp edges and
moving parts of the appliance. Damaged or entangled cables increase the
risk of an electric shock.
e) If you are working outdoors with an electric tool, only use extension
cables which are designed specifi cally for this purpose. Using specially
designed outdoor extension cables, the risk of electric shock is reduced.
f) If operation of the electric tool in a damp environment can not be avoi-
ded, use a earth-leakage circuit-breaker. The earth-leakage circuit-breaker
reduces the risk of an electric shock.
3. Safety of persons
a) Be careful, watch what you are doing and use an electric tool sensibly.
Do not use the tool if you are tired or under the infl uence of drugs, alco-
hol or medication. A moment of inattention when using the electric tool can
result in serious injuries.
b) Wear personal protection equipment and always wear safety goggles.
Wearing personal protection (such as dust masks, non-slip safety shoes, safety
helmet or ear protection, depending upon the type and use of the electric tool)
reduces the risk of injury.
c) Make sure that the appliance cannot start up accidentally. Ensure that
the electric tool is switched off before you connect it to the power supply
and/or insert the battery, or pick up or carry the tool. If your fi nger is on
the switch whilst carrying the electric tool or if you connect the appliance to the
mains when it is switched on, this can lead to accidents.
d) Remove keys and wrenches before switching on the electric tool. A tool
or key which comes into contact with rotating parts of the appliance can lead to
injuries.
e) Avoid abnormal working postures. Make sure you stand squarely and
keep your balance at all times. In this way, you can control the electric tool
better in unexpected circumstances.
f) Wear suitable work clothes. Do not wear loose clothing or jewellery. Keep
hair, clothes and gloves away from moving parts. Loose clothing, jewellery
or long hair can get trapped in moving parts.
g) If vacuuming devices and draining devices can be fi tted, make sure that
these are correctly attached and correctly used. The use of a dust extrac-
tion system can reduce the danger posed by dust.
h) Use clamps or some other means to fasten and secure the workpiece to
a sturdy surface. If you hold the workpiece only with your hand or against your
body it will remain unstable and might cause you to lose control.
Anl_BT_KF_150_SPK7.indb 25 Anl_BT_KF_150_SPK7.indb 25
GB
- 25 -
23.06.2016 09:28:58 23.06.2016 09:28:58