Operation; Continuous Operation - EINHELL BT-KF 150 Originalbetriebsanleitung

into the tool, which could present a risk of an electric shock for the operator.
Trip the miniature circuit-breaker or take out the fuse in order to disconnect the ap-
plicable electric circuit from the power supply.

6. Operation

6.1 On/Off switch (Fig. 3)
Switching on:
Press the ON/OFF switch (4).
Switching off :
Release the ON/OFF switch (4).

Continuous operation:

Press the ON/OFF switch (4) and lock it with the lockable ON switch (1).
To switch off , press the ON/OFF switch (4) briefl y and let go.
6.2 Adjusting the speed (Fig. 4)
Turn the speed controller (2) in the plus direction to increase the speed of rotation.
Turn the speed controller (2) in the minus direction to reduce the speed of rotation.
6.3. Changing a tool (Fig. 5)
Note:
Only use combination cutter accessories with shaft diameters of 4.7 mm. Press
and hold the spindle locking button (11). Undo the clamp nut (10) with the open-en-
ded wrench (14) and then change the tool. Block the spindle lock again afterwards
and tighten the clamp nut (10) securely using the open-ended wrench (14).
Multi-purpose cutter (HSS) (18):
Purpose: Wood, particleboard, plastic
Groove cutter (HSS) (17):
Purpose: Wood, particleboard, plastic
Sanding/grinding belts (16):
Purpose: Sanding wood
Anl_BT_KF_150_SPK7.indb 31 Anl_BT_KF_150_SPK7.indb 31
GB
- 31 -
23.06.2016 09:28:59 23.06.2016 09:28:59