Connecting The Display - 3M MicroTouch M1500SS Bedienungsanleitung

3M™ MicroTouch™ Display M1500SS User Guide

Connecting the Display

To connect the M1500SS Display:
Turn off your computer. You should always turn off the computer before connecting
1.
or disconnecting any device.
Connect one end of the video cable to the video connector on the display. Connect
2.
the other end to the video card in your computer.
Connect one end of the touch sensor cable (either serial or USB) to the display.
3.
Connect the other end to an available port on the back of your computer. If you are
using a USB connection, make sure you have installed the Touch Software drivers
prior to connecting the touch sensor cable.
Plug the AC/DC power supply into the M1500SS Display. Be sure to use the power
4.
supply included with the display.
Figure 9 Identifying Your Display Connections
Touch Sensor
Microphone out
Connect the power cable to the AC/DC supply. Connect the other end to the
5.
appropriate AC outlet.
Figure 10 Connecting the M1500SS Cables to your Computer
3M Touch Systems, Inc. Proprietary Information
Power
Line In
11
Video Connection