Access To The Video Controls; Clearance And Ventilation; Connecting The Touch Display - 3M MicroTouch C1500SS Installationsanleitung

6
The C1500SS hardware accessory kit includes two brackets, washers, and screws. The
mounting holes are located on the sides of the display and are threaded to an M4 thread.
The brackets are slotted, allowing the chassis to slide in and out. You can also rotate the
brackets to various positions.
The unit has a 75mm VESA mounting pattern on the back case to allow for arm mount
capability.
Note: Do not mount the chassis unit directly from the rear of the cover. Always use the
holes and brackets provided. Do not drill additional holes in the unit to mount brackets in
other locations.

Access to the Video Controls

The controls for adjusting the video display are located on the back of the C1500SS
Display. These buttons let you display the on-screen menu and adjust the phase, image
position, contrast, and brightness.

Clearance and Ventilation

Leave at least two inches of clearance space behind the C1500SS Display for proper
ventilation. Units have vent holes at the top and bottom on the back of the chassis --
ensure these holes are not blocked during installation. Always maintain adequate
ventilation to protect the display from overheating and to ensure reliable and continued
operation. Refer to the published specifications for the maximum and minimum
operating temperature and humidity conditions.

Connecting the Touch Display

To connect the C1500SS Display
1. Turn off your computer.
2. Connect one end of the video cable to the video connector on the FPD. Connect the
other end to the video card in your computer.
3. Connect one end of the touch sensor cable (either serial or USB) to the FPD.
Connect the other end to an available port on your computer. Make sure you have
installed the Touch Software drivers before connecting the touch sensor cable.
TSD-30219
3M™ MicroTouch™ Display C1500SS Installation Guide
Rev F