Display Installation Problems - 3M MicroTouch C1500SS Installationsanleitung

14

Display Installation Problems

No image displayed Is the display receiving power?
(blank screen)
Is the display receiving a valid video signal from the PC?
Is the display in Power Management mode?
 If the LED on the rear of the display is flashing orange/red, touch the
Are the brightness and contrast settings too low?
Abnormal image
Colors of image are
abnormal
Disturbances on the
screen
TSD-30219
 Check that the computer's power cable is connected properly and
securely into a grounded electrical outlet.
 Check that the AC input jack is firmly plugged into the display.
 Check that the display's power cable is connected properly and
securely to an electrical outlet.
 Try using another power cable.
 Try using another electrical outlet.
 Check that the computer is powered on.
 Check that the video cable is connected properly and securely to the
display and the computer.
 Check that the LED on the rear of the unit is green.
 Check that no pins are bent in the video cable connector.
 Check that the video card is firmly seated in the card slot in your
computer.
 Check that the video input from the video card falls within the refresh
rate of the display. Refer to Table 1 for details.
 Check that your computer is using a supported display mode. Refer to
Table 1 for details.
screen, press any key on the keyboard, or move the mouse to restore
operation.
 Use the display controls to adjust these values.
 Check that the video input from the video card falls within the refresh
rate of the display. Refer to Table 1 for details.

Check that the video cable is connected properly and securely to the
display and the computer.
 Check that the video cable is connected properly and securely to the
display and the computer.
 Check that no pins are bent in the video cable connector.

The video display adjustments are incorrect. Refer to Chapter 3 for
adjusting procedures.
Rev F
3M™ MicroTouch™ Display C1500SS Installation Guide