Connectors And Buttons - Axis M7014 Installationsanleitung

Network LED
Green
Amber
Unlit
Power LED
Green
Amber

Connectors and Buttons

For specifications and operating conditions, see page 13.
BNC Connector
Each video input is terminated using a coax/BNC connector.
Connect a 75 Ohm coaxial video cable; the recommended maximum length is 250 m (800 ft).
Note
75 Ohm video termination can be enabled/disabled for the video input through the
product's web page at Video > Camera Settings > Video termination. Video termination is
enabled on factory default. If the product is connected in parallel with other equipment,
for optimum video quality, it is recommended that video termination is enabled only for
the last device in the video signal chain.
Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO TICE NO NO TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC) 2 .
AXIS M7014 Video Encoder
Indication
Steady for connection to a 100 Mbit/s network. Flashes for
network activity.
Steady for connection to a 10 Mbit/s network. Flashes for
network activity.
No network connection.
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
11