Sd Card Slot; Buttons; Connectors - Axis Q7424-R Mk II Handbuch

AXIS Q7424-R Mk II Video Encoder
Power LED
Green
Amber

SD card slot

NO TICE TICE
NO NO TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when
inserting or removing the SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product
is running. Disconnect power or unmount the SD card from the Axis product's webpages
before removal.
This product supports SD/SDHC/SDXC cards (not included).
For SD card recommendations, see www.axis.com

Buttons

Control Button
For location of the control button, see Hardware Overview on page 10.
The control button is used for:
• Resetting the product to factory default settings. See page 13.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic DNS
Service. For more information about these services, see the User Manual.

Connectors

Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
The unit can only use one Network interface, either an SFP module or RJ45 connector. SFP module
has higher priority than the RJ45 connector.
NO TICE TICE
NO NO TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC) 2.
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
16