Timer Function; Sound Signalization - Concept OV2000 Bedienungsanleitung

EN
Silent mode
In this mode, the airflow rate is low and humidity level can be set at 35-80 % (by 5 % steps).
Drying mode
In this mode, the airflow rate is high, thus the dehumidification rate is increased, but the humidity level cannot be
adjusted.
Continuous mode
In this mode, the compressor is in a standby mode, the airflow rate is low and the humidity level cannot be adjusted.
Automatic mode
In this mode, the humidity level is set to 55 % as default and it cannot be adjusted, the airflow rate adjusts
automatically according to the humidity in the room (humidity lower than 70 % means higher flow speed, humidity
below 55 % means lower flow rate).
Defrosting function
When defrosting, the LED lights up, the compressor stops operating and the ventilator continues rotating.
Full tank function
Once the water tank is full, the LED lights up and the sound signal occurs. When the tank is empty, operation will
continue.
Air purification function
Press the Air Clean button to launch the air cleaning mode. The ventilator is rotating, the compressor is not operating.

Timer function

• Press the Timer button to turn the LED on and use the + and - buttons to set the desired operation time (0-24 hours).
Press the button for the second time to display the remaining time.
• Prior to setting the operation time, make sure the timer function is activated (the LED must be on).
• The timer stops if the water tank is full. Once the tank is empty, the timer will start again.
Following timer functions are available:
1. Delayed shutdown function (appliance is operating)
The appliance switches off automatically when the preset time runs out.
2. Delayed start function
The appliance switches on automatically when the preset time runs out.
After a certain time, the timer LED lights up to indicate the remaining time.
Setting the humidity level
Use the + and - buttons to set the humidity level in range of 35-80 % (by 5 % steps).
Setting the angle of the flap
Press the OSC button and set the angle of the air outlet flap, the LED lights up. Press the button again to confirm.

Sound signalization

Every time you press the button, the sound signal occurs.
58
OV2000