Input Signal Warning Function; Use Of The Tilt-Swivel; Specifications - Sony Multiscan GDM-W900 Bedienungsanleitung

Input Signal
Warning Function
If there is something wrong with the input signal, one of the
following messages appears when you turn the monitor off
and on, or when you operate the INPUT switch.
The message disappears after about 30 seconds.
PLEASE CHECK THE S I GNAL
I NPUT : HD1 5
FH : 84.4kHz FV : _ Hz
1 Shows the INPUT switch setting.
2 Shows the input signal condition.
"FH: - kHz" indicates no horizontal sync signal.
"FV: - Hz" indicates no vertical sync signal.
"OUT OF SCAN RANGE" indicates that the input signal
is not supported by the monitor's specifications.
"NO CONNECTION" indicates that the supplied video
signal cable is disconnected from the HD15 connector
when the INPUT switch is set to "HD15."
18
Use of the Tilt-
Swivel
With the tilt-swivel, this unit can be adjusted to be viewed
at the desired angle within 310° horizontally and 20°
vertically.
To turn the unit vertically and horizontally, hold it at its
bottom with both hands as illustrated below.
155°
15°
5°

Specifications

Picture tube 0.25 – 0.28 mm aperture grille pitch
24 inches measured diagonally
90-degree deflection
Approx. 482 × 304 mm (w/h)
Viewable image size
(19 × 12 inches)
22.5" viewing image
Resolution Horizontal: Max. 1920 dots
Vertical: Max. 1200 lines
Approx. 473 × 296 mm (w/h)
Standard image area
(18
Deflection frequency Horizontal: 30 to 96 kHz
Vertical: 50 to 160 Hz
Input HD15 (1), 5 BNC (1)
R/G/B: 75 Ω, 0.714 Vp-p, positive
HD/VD or Composite sync
Sync-on-green: 0.286 Vp-p,
negative
AC input voltage/current
100 to 120 V, 50/60 Hz, 2.2 A
200 to 240 V, 50 – 60 Hz, 1.4 A
Power consumption Max. 200 W
580 × 500 × 548 mm (w/h/d)
Dimensions
(22
Mass Approx. 41 kg (90 lb 6 oz)
Design and specifications are subject to change without
notice.
155°
× 11
5 3
/ / inches)
8 4
× 19 × 21
7 3 5
/ / / inches)
8 4 8