Storage Of Measuring Results; Manual Storage; Automatic Storage; Recalling Stored Results - Anton Paar DMA 35N Betriebsanleitung

8.3

Storage of Measuring Results

8.3.1 Manual Storage

• A long push of the "store" key immediately stores the current measuring result in
the memory together with a sample number.
• "HOLD" is displayed.
• The sample number starts at 1 and is automatically increased by one with each
new stored measuring value.
• 1024 results can be stored.

8.3.2 Automatic Storage

• A short push of the "store" key activates the automatic storage procedure.
• "AUTO" is displayed.
• The instrument automatically checks the temperature stability of the sample. If
temperature is stable within 0.2 degrees for 10 subsequent measurements, then
the value is automatically stored together with a sample number.
• A minimum of 15 seconds is required per automatic storage procedure.
8.4

Recalling Stored Results

• A short push of the "Recall/Delete" key shows the latest stored value on the
display for 10 seconds.
• If the "Recall/Delete" key is pushed again shortly within this time, subsequently
all stored results can be displayed from the latest to the oldest value.
• If the key is not pushed within 10 seconds the display is switched back to the
current measuring value.
B46IB01
Hints:
• No storage is possible if the "low battery" sign appears on
the display.
• Activating the "SET" mode deletes all stored results.
25