Overview; Introduction; Customer Responsibility; Installation Time Schedule - HP DESIGNJET L26500-Serie Handbuch Zur Vorbereitung Des Aufstellungsorts

1

Overview

Introduction

Your printer is supplied ready to use after a few simple installation procedures described in detail in the
Assembly instructions. It is important to read the information provided in this guide thoroughly and to
ensure complete compliance with all installation and operation requirements, safety procedures,
warnings, cautions and local regulations. A well prepared site helps to provide a smooth and easy
installation.

Customer responsibility

You are responsible for preparing the physical site for the installation of the printer.
Prepare the building's electrical system to meet the printer's requirements and the Electrical Code
●
requirements according to the local jurisdiction of the country where the equipment is installed,
and power up the printer on the day of installation. See
NOTE: Make sure that a certified electrician reviews the setup and configuration of the electrical
system used to power the printer. See
Meet temperature and humidity requirements and ensure proper ventilation for the printer. See
●
Environmental specifications on page
Meet all requirements for RIP, networking and printing supplies. See
●
on page 4,
Prepare the unloading route so the printer can be unloaded and maneuvered into place. See
●
Unloading route on page

Installation time schedule

Allow a minimum of three hours for the installation. The installer may require the help of three people to
perform certain tasks during installation.
ENWW
3.
Networking on page 4 and
2.
Electrical configuration on page
Electrical configuration on page
Printing supplies on page
4.
4.
RIP workstation characteristics
4.
Introduction
1