HP DESIGNJET L26500-Serie Handbuch Zur Vorbereitung Des Aufstellungsorts Seite 13

Electrical installation requirements
Are the wall receptacles (wall sockets) placed close enough to the printer
that the plugs can be plugged and unplugged easily?
NOTE: The power cord length is 4.5 m (14.8 ft).
Would the printer's built-in Residual Current Circuit Breaker (also known as
Ground Fault Circuit Interrupter) operate in the case of a current leakage
fault to the product chassis (even if an isolation device is installed)?
Electrical configuration requirements
Do you need an Uninterrupted Power Supply (UPS) or step-up transformer? If
so, is it correctly installed?
Networking and computer requirements
Is the RIP computer and software ready for installation?
Have network connections been supplied?
Do you have a color sensor that is compatible with your RIP?
Do you have a LAN cable long enough to connect the printer to the
network?
Environmental requirements
Have the temperature and humidity requirements been satisfactorily met in
the print production area, and is there adequate ventilation or air
conditioning?
Have the temperature and humidity requirements been satisfactorily met in
the storage area?
Is the print production area free from dirt and dust?
Does the print production area have sufficient lighting?
Other requirements
Have you arranged for supplies such as substrate and ink cartridges to be
available on the day of installation?
Have you met the requirements specified in this guide?
ENWW
Yes No Comments
(Required)
(Required)
Yes No Comments
Yes No Comments
Yes No Comments
Yes No Comments
(Required)
9