Optional Accessories - Makita BO4555 Bedienungsanleitung

Installing paper dust bag
(accessory)
► Fig.7: 1. Groove 2. Front fixing cardboard 3. Front
side of paper dust bag
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing card-
board of the paper dust bag into the groove of the paper
dust bag holder.
Then press the upper part of the front fixing cardboard
in arrow direction to hook it onto the claws.
► Fig.8: 1. Claws 2. Upper part
Insert the notch of the paper dust bag into the guide of
the paper dust bag holder. Then install the paper dust
bag holder set on the tool.
► Fig.9: 1. Notch 2. Guide
► Fig.10
Installing paper filter bag
► Fig.11: 1. Holding tab
Make sure that the logo on the cardboard lip and the
logo on the dust box are on the same side, then install
the paper filter bag by fitting the cardbord lip in the
groove of each holding tab.
► Fig.12: 1. Dust box 2. Dust nozzle
Make sure that the logo on the cardboard lip and the
logo on the dust nozzle are on the same side, then
install the dust nozzle on the dust box.
Removing dust box and paper filter bag.
► Fig.13: 1. Latch 2. Dust nozzle
Remove the dust nozzle by pushing the two latches.
► Fig.14
Remove the paper filter bag first by pinching the logo
side of its cardboard lip, then by pulling the cardboard
lip downwards to move it out of the holding tab of the
dust box.
OPERATION
Sanding operation
► Fig.15
CAUTION:
• Never run the tool without the abrasive paper.
You may seriously damage the pad.
• Never force the tool. Excessive pressure may
decrease the sanding efficiency, damage the
abrasive paper and/or shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. A finishing sander is generally used
to remove only a small amount of material at a time.
Since the quality of the surface is more important than
the amount of stock removed, do not bear down on the
tool. Keep the base flush with the workpiece at all times.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
• Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
To maintain product SAFETY and RELIABILITY,
repairs, carbon brush inspection and replacement, any
other maintenance or adjustment should be performed
by Makita Authorized Service Centers, always using
Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Abrasive paper (without pre-punched holes)
• Paper dust bag
• Paper dust bag holder
• Punch plate
• Dust bag
• Dust box
• Paper filter bag
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
6 ENGLISH