Installation - Sharp SJ-MB300S Bedienungsanleitung

Thank you very much for buying this SHARP product. Before using your SHARP refrigerator, please read this operation
manual to ensure that you gain the maximum benefit from it.
WARNING
This refrigerator contains flammable refrigerant (R600a:
●
isobutane) and insulation blowing gas (cyclopentane).
Observe the following rules to prevent ignition and
explosion.
• The refrigeration system behind and inside the
refrigerator contains refrigerant. Do not allow any
sharp objects to come into contact with the
refrigeration system.
• Do not use mechanical devices or other means to
accelerate the defrosting process. (This refrigerator
has adopted automatic defrosting system.)
• Do not use electric appliances inside the refrigerator.
• Use only the specified parts for the refrigerator
compartment light.
• Do not block the openings on the circumference of the
refrigerator.
• If the refrigeration system should get punctured, do not
touch the wall outlet and do not use open flames. Open
the window and air out the room. Then ask a service
agent approved by SHARP for servicing.
• This refrigerator should be disposed appropriately.
Take the refrigerator to a recycling plant for flammable
refrigerant and insulation blowing gases.
Highly volatile and flammable materials such as ether,
●
petrol, propane gas, adhesive agents and pure alcohol
etc. are liable to explode. Do not store these materials in
the refrigerator.
Dust deposited on the power plug may cause fire. Wipe
●
it off carefully.
Do not attempt to change or modify this refrigerator. This
●
may result in fire, electric shock or injury.
Ensure that the refrigerator presents no danger to
●
children while being stored for disposal. (e.g. remove the
magnetic door seals to prevent child entrapment.)

INSTALLATION

1
Keep adequate ventilation space around the refrigerator.
• The figure shows the minimum required space for installing the refrigerator.
It differs from the space in the measurement condition of the amount of power
consumption.
• It is possible to use the refrigerator with a less amount of power consumption by
keeping greater space.
• If using the refrigerator in the space below dimension of the figure, it may cause
the temperatures in the unit to rise, loud noise, and failure.
2
Using the two front adjustable feet, ensure that the refrigerator is positioned
firmly and level on the floor.
3
Remove the 2 screws of the cabinet lower part, and use these to fit the foot
cover. (supplied inside the refrigerator compartment)
WARNING
Do not install the refrigerator in a damp or wet location as this may cause damage to
the insulation and a leak. Condensation may also build on the outer cabinet and
cause rust.
NOTE
•
Position your refrigerator so that the plug is accessible.
•
Keep your refrigerator out of direct sunlight.
•
Do not place next to heat generating appliance.
•
Do not place directly on the ground. Provide suitable stand.
•
To insert the power plug when the door is opened, door alarm sounds but it is not
abnormal. This sound stops when closing the door.
When transporting
• Using the casters, it is possible to move back and forth.
Impossible movement and movement in a transverse
direction damage a floor.
• Carry the refrigerator by holding the handles located on
the rear and the adjustable feet at the bottom.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
2
CAUTION
Do not touch foods or metal containers in the freezer
●
compartment with your wet hands. This may cause
frostbite.
Do not use an extension cord or adapter plug.
●
Do not place bottled and canned drinks in the freezer as
●
they may crack when frozen.
Make sure that the power cord has not been damaged
●
during installation or moving. If the power plug or cord is
loose, do not insert the power plug. There is a risk of
electric shock or fire.
Disconnect from the mains electricity supply by
●
removing the mains plug from the electricity supply
socket. Do not remove by pulling the mains lead. This
may cause electric shock or fire.
Should the flexible supply cord be damaged, it must be
●
replaced by service agent approved by SHARP as a
special cord is required.
In case of gas leak, ventilate the area by opening a
●
window, etc. Do not touch the refrigerator or the power
outlet.
Do not place objects containing liquid or unsteady
●
objects on top of refrigerator.
This refrigerator is not intended for use by persons
●
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the refrigerator by a person
responsible for their safety. Young children should be
supervised to ensure that they do not play with the
refrigerator.
rear
Casters
60mm
1
or more
90mm or more
60mm
or more
1110 mm
2
Adjustable
foot
3
Screws
Foot cover
bottom