Installation Menu - Caleffi 210 Serie Anleitung Für Installationund Inbetriebnahme

INST LL TION MENU
(to bind devices, modify zones, optional functions)
Starting from the main menu select:
CAuTION! Changes could lead to anomalous behaviour of the system.
ZONE MANAGEMENT
ADD
DELETE
TEST
NAME
RADIATOR
ADD ZONE
DELETE ZONE
SENSOR CALIBRATION
RF ACCESSORIES
OPTIONAL FUNCTIONS
PASSWORD PROTECTION
SELF-LEARNING
RESET
–>
MENU
Allows adding a temperature sensor / window sensor / actuator to the selected zone.
Allows deleting binding to the temperature sensor / window sensor / actuator in the selected zone.
Two functions can be performed:
- EST RF: performs a communication test with the temperature data measured (for the
temperature sensor) or opening/closing position of the valve (for the actuator) and
displays the signal level (DB-LINK). Data are upgraded immediately.
- OPEN/CLOSE: performs a full opening/closing procedure of the obturator
(temporary for 10 minutes) Follow the on-screen instructions.
Allows changing the zone name.
Allows changing the type of radiator bound to the actuator/valve.
llows to add a zone and specific sensor/actuators. Follow the on-screen instructions.
allows to eliminate a zone. Follow the on-screen instructions.
This function allows setting the offset value for the sensor integrated in the thermostat.
This option can be activated, for example, when the controller is positioned in a place where it
does not correctly measure the temperature (e.g. it is not positioned at a height between 1,2 and
1,5 metres from the ground) or close to a heat source.
Allows adding a click switch (optional). Follow the on-screen instructions.
Activate this function if you want to block access to the controller by selecting a number
from 0 to 999. The user will be asked to enter the same number (password) each time
an operation should be carried out. The password will be requested each time the
controller is turned on.
CAUTION! Carefully note down the password to prevent making the system
unusable. Follow the on-screen instructions. Should you forget the password,
contact Caleffi Technical Support to perform a reset procedure and restore control
unit operation (however, you will lose all the settings).
Enabling or disabling this function, the controller will adapt the system activation and
deactivation times to the thermal characteristics of the house, optimising the system time
response (self learning). Default function is disabled. Follow the on-screen instructions.
CAuTION! This function restarts the system. You will lose all the data and will have to
repeat the device binding operations. Follow the on-screen instructions.
–>
INSTALLATION
20
PRESS OK FOR 5 SEC