Binding The Controller To The Temperature Sensor - Caleffi 210 Serie Anleitung Für Installationund Inbetriebnahme

Binding the controller to the temperature sensor

THU THU
LIVING ROOM LIVING ROOM
24/04/14 24/04/14
TEMPERA TEMPERATURE SENSOR PERA A TURE SENSOR
WINDOW SENSOR WINDOW SENSOR
ACTUA A TOR ACTUATOR
ADD ADD
THU THU
LIVING ROOM LIVING ROOM
24/04/14 24/04/14
NOW PRESS THE SENSOR BUTTON NOW PRESS THE SENSOR BUTTON NOW PRESS THE SENSOR BUTTON
WITHIN 2 MINUTES WITHIN 2 MINUTES
USING A SUIT USING A SUITABLE TOOL SING A SUIT TABLE TOOL
YOU ARE ADDING A SENSOR YOU ARE ADDING A SENSOR YOU ARE ADDING A SENSOR
THU THU
LIVING ROOM LIVING ROOM
24/04/14 24/04/14
YOU HAVE SUCCESSFULLY YOU HA U HA AVE SUCCESSFULL VE SUCCESSFULL LY
BOUND THE TEMPERA BOUND THE TEMPERATURE UND THE TEMPERA ATURE
SENSOR IN THE ZONE: LIVING ROOM SENSOR IN THE ZONE: LIVING ROOM SENSOR IN THE ZONE: LIVING ROOM
PRESS ANY BUTTON PRESS ANY BUTTON
14:48 14:48
TURE SENSOR
TOR
14:48 14:48
ABLE TOOL
14:48 14:48
Y
TURE
4.
Mount the sensor on the wall using the both sides adhesive tape provided or a flat
screw using the dedicated hole on the baseplate.
The temperature sensor is supplied completely discharged but needs to
have a charge level sufficient to be bound to the controller. It is however
sufficient to position it in an illuminated environment for 2 hours to reach
the minimum charge level necessary for binding. Direct exposure to
sunlight or heat source falsifies the actual ambient temperature reading.
Position the sensor far away from doors, windows, radiators and indirect
heating sources, possibly at a height between 1,2 and 1,5 metres from the
ground.
1.
Select TEMPERATuRE SENSOR from the ADD menu.
1a.
Press any button to start the binding procedure.
2.
Press the sensor button within two minutes.
For binding use a thin pointed
object, for example, a paper
clip. Insert the tip in the
dedicated hole on the rear of
the temperature sensor.
3.
If the operation was successful, a confirmation
message is displayed. If binding failed, an alarm
signal is displayed. In this case, repeat the
procedure or consult the section ERRORS/ALARMS.
14